Future Design
Bubble Width Control System
The Future Design Bubble Width
Control System incorporates three ultrasonic sensor
modules, equally spaced around the blown film bubble, to
continuously monitor the size of the bubble stalk. The unit
monitors and intervenes when necessary, to maintain or modify the
size of the bubble to acquire desired layflat. This will enable
the blown film line to consistently produce uniform film widths
within ± 0.063 inch tolerance.
MODEL
BWC-03
Benefits:
- Bubble diameter
consistency
- Reduced scrap
- Faster detection of
unplanned bubble inflation or deflation with immediate
response
- No operator input needed to
maintain the required film size
- Low acquisition and
installation cost
- Reduced concerns about
accidental bubble deflation
- Very limited training
required for the line operators with no computer skills
required
Comes Complete With The Following:
- Three (3) high-tech sensor
modules
- Electrical control panel
featuring MFD Titan control, programmable buttons, and capable
of accepting fully customizable graphic user
interface
- Pneumatic panel featuring an
adjusting valve to fine-tune the inflation/deflation air to the
bubble
- Pneumatic panel separate
from electric panel so that condensation and air exhaust from
the pneumatics will not affect the electronic modules and
electric circuits
- Panels mounted on a single
steel stand
- Pressure regulator -
recommended to operate at 25 psi
- Comes complete with all air
valves, tubes and fittings
- Compressed shop air
required
- 110V power supply
required
- Custom mounting brackets to
be quoted upon request
Please contact Future Design if you have any
questions,
or if you would like a quotation for the Future Design
Bubble Width Control System.
Site best viewed at a resolution of at least 1024 x 768 pixels
Copyright © 2004-
Future Design Inc. All rights reserved.
futurecan@saturn2.com